CONTACTS

The SRA CB-1 and SRA LP-1 are best attached to permanantly mounted stainless steel eye-pads and stainless steel hardware.For occasions where the SRA devices are to be utilized on rented or borrowed kayaks and canoes, please utilize the recommended procedures below:

1. For the attachment of the SRA CB-1 bronze eye-snap to the kayak attachment cord: Utilizing an approx 3 foot long #4 solid braided nylon cord with a minimum 40 pound tensile strength rating, tie a double overhand loop knot at one end of the cord, thread other end of cord through and around the mounting bolts of two adjacent eye-pads (or recessed eye pads as typically found on newer kayaks). Feed loose end of the cord through the loop eye, pull tightly and secure with two overhand knots (see Photo #1). Attach the SRA CB-1 bronze eye-snap to any point along the nylon cord (see Photo #2).

2. For the attachment of the SRA CB-1 bronze eye-snap to the canoe yoke: Utilizing an approx 3 foot long 1/4" diameter nylon or polyester rope. Tie a clove hitch around the mid-section of the yoke, followed up with a square knot. Attach bronze eye-snap to the rope as shown in Photo #3.

For the attachment of the two SRA LP-1 bronze eye-snaps to the kayak's fore and aft hatch cover web straps as shown in Photo #4:

a. Acquire a 3 foot long 1/4" diameter nylon or polyester rope. On the front hatch cover web straps, tie separate clove hitches around each of the two web straps as shown in Photo #5. Attach the LP-1 bronze eye-snap to the center of the rope.
b. Acquire another 3 foot long 1/4" diameter nylon or polyester rope. On the rear hatch cover web straps, tie separate clove hitches around each of the two web straps as shown in Photo #6. Attach the LP-1's other bronze eye-snap to the center of the rope as shown in Photo #6.

4. Canoe Option 1: For the attachment of the SRA LP-1's bronze eye-snap to the canoe yoke, loop and adjust ladder platform rope around the yoke as shown in Photo #7.

5. Canoe Option 2: For the attachment of the SRA LP-1's bronze eye-snaps to the canoe's bow and stern seats, loosely attach a 3 foot long 1/4" diamenter nylon or polyester rope around each of the bow and stern seats using a square knot. Attach the forward and rear bronze eye-snaps to the middle of the rope as shown in Photo #8 and #9 respectively.